2002 BMW 3 Series

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Shock absorbers has a reduced damping effect all (5.3.2 (d))

Suspension arm corroded but not seriously weakened all (5.3.3 (b) (i))

Suspension arm pin or bush worn but not resulting in excessive movement all (5.3.4 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Rear fog lamp tell-tale not working (4.9.1 (a) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Shock absorbers has a reduced damping effect all (5.3.2 (d))

Suspension arm corroded but not seriously weakened all (5.3.3 (b) (i))

Suspension arm pin or bush worn but not resulting in excessive movement all (5.3.4 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Lower Suspension arm ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Offside Front Anti-roll bar ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Electronic stability system warning lamp indicates a fault (3.4.1c)

Nearside Front Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Offside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)