2004 Mazda 6

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Brake performance not tested (1.2.1 (g))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Emissions not tested (8.2.1.2 (d))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively damaged significantly reducing structural strength (5.3.6 (a) (i))

Offside Headlamp levelling device inoperative (4.1.5 (a))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Offside Rear Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively damaged significantly reducing structural strength (5.3.6 (a) (i))

Rear Brake pipe excessively corroded (1.1.11 (c))

Fluid leak, but not excessive coolant (8.4.1 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

underside in general rusty condition

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

underside has slight surface corrosion

Rear Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt BOTH (2.4.G.2)

Rear Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt BOTH (2.4.G.2)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)