2011 Audi A3

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources LED (4.7.1 (b) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge edge worn (5.2.3 (e))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear sub-frame and suspension components covered in surface rust but feel solid

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Emissions unable to be completed exhaust not attached (centre pipe) (8.2.2.2 (e))

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources LED (4.7.1 (b) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge edge worn (5.2.3 (e))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear sub-frame and suspension components covered in surface rust but feel solid

Central Exhaust has a minor leak of exhaust gases exhaust centre/down pipe sleeve rusty tiny split (6.1.2 (a))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear brake backing plate rusty

Rear Outer Brake disc worn, pitted or scored, but not seriously weakened faces x2 (1.1.14 (a) (ii))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Headlamp aim too low (1.8)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

exhaust emissions too clean for print out

Nearside Front Tyre tread depth below requirements of 1.6mm 225/40/18 (4.1.E.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

exhaust emissions too clean for print out

exhaust heat shields,o/s/r suspension arm slight corrosion,undertrays and engine covers fitted as standard,obscuring some testable components.

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components