MOT Status
ExpiredMileage
190,351 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Exhaust catalytic converter missing where one was fitted as standard (8.2.2.1 (a))
Front Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))
Nearside Front Direction indicator not working (4.4.1 (a) (ii))
Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))
Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))
Nearside Front Position lamp not working (4.2.1 (a) (ii))
Nearside Front Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))
Nearside Rear Vehicle structure excessively corroded within 30cm of towbar mounting cross member (6.1.6 (i) (i))
Offside Front Service brake excessively binding (1.2.1 (f))
Offside Front Side repeater not working (4.4.1 (a) (ii))
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill near arm mount (5.3.6 (a) (i))
Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting cross member (6.1.6 (i) (i))
Parking brake efficiency below requirements (1.4.2 (a) (i))
Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))
Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS
Battery insecure but not likely to fall from carrier (4.13 (a) (i))
Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill near arm mount (5.3.6 (a) (i))
Offside Front Road wheel slightly distorted (5.2.2 (c) (i))
Offside Outer sill corroded
all brake pipes have been greased
Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))
Brake load sensing valve linkage defective and function impaired (1.1.17 (a))
Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))
Exhaust has a minor leak of exhaust gases (6.1.2 (a))
Nearside Rear Towbar slightly corroded within 30cm of towbar mounting (6.1.6 (i) (i))
Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)
Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)
Body has slight corrosion (6.1.B.2)
Inner Body has slight corrosion (6.1.B.2)
Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
Nearside Rear Brake pipe slightly corroded (3.6.B.2c)
Offside Front Brake pipe slightly corroded (3.6.B.2c)
Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
Offside Rear Brake pipe slightly corroded (3.6.B.2c)
Outer Body has slight corrosion (6.1.B.2)
Play in steering rack inner joint(s)
Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)
Nearside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)
Body has slight corrosion (6.1.B.2)
Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)
Inner Body has slight corrosion (6.1.B.2)
Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)
Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
Nearside Rear Brake pipe slightly corroded (3.6.B.2c)
Offside Front Brake pipe slightly corroded (3.6.B.2c)
Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
Offside Rear Brake pipe slightly corroded (3.6.B.2c)
Outer Body has slight corrosion (6.1.B.2)
Play in steering rack inner joint(s)
Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)
Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)
Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)
Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)
Offside Front coil spring broken (2.4.C.1a) DANGEROUS
Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)
Front Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)
Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)
Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)
Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)
Body has slight corrosion (6.1.B.2)
Nearside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)
Brakes imbalanced across an axle (3.7.B.5b)
Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Offside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)
Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Body has slight corrosion (6.1.B.2)
Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
Nearside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)
Nearside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)
Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)
Rear Brake pipe slightly corroded (3.6.B.2c)
Corrosion on rear brake disc`s
Centre Exhaust has a major leak of exhaust gases (7.1.2)
Emissions not tested (7.0)
Nearside Front coil spring fractured (2.4.C.1a)
Offside Registration plate lamp not working (1.1.C.1d)
Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)
Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)
Front registration plate character(s) laid out in an incorrect format (6.3.4f)
Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)
Rear registration plate character(s) laid out in an incorrect format (6.3.4f)
Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Nearside Rear Tyre worn close to the legal limit (4.1.E.1)
Offside Rear Tyre worn close to the legal limit (4.1.E.1)
front wipers judder across screen
Nearside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)
Offside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)
Nearside Rear Tyre worn close to the legal limit (4.1.E.1)
Nearside Side repeater incorrect colour (1.4.A.2f)
Offside Rear Tyre worn close to the legal limit (4.1.E.1)
front wipers judder accross screen
How Reliable is the Mercedes-benz Vito?
Based on 2,011,702 MOT tests across 164,434 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
AY03 FUM is a 2003 Mercedes-benz Vito in White with a 2,151cc diesel engine. This vehicle has been through 24 MOT tests with a personal pass rate of 62.5%.
Across all 2003 Mercedes-benz Vito models, the average MOT pass rate is 66.0% with a typical mileage of 105,209 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Mercedes-benz Vito fails its MOT is parking brake: efficiency below requirements, accounting for 49,564 recorded failures. If you're considering buying AY03 FUM, it's worth having these areas checked by a mechanic before committing.
The Mercedes-benz Vito typically stays on UK roads for around 29 years. At 23 years old, this Mercedes-benz Vito is well into its expected lifespan but still has years ahead.
Frequently Asked Questions
How do I check the history of AY03 FUM?
You can check the full history of AY03 FUM by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was AY03 FUM registered?
AY03 FUM is a 2003 Mercedes-benz Vito, first registered on 1 April 2003.
Is AY03 FUM safe to buy?
The MOT history for AY03 FUM shows 24 tests with a 62.5% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does AY03 FUM have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on AY03 FUM. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.