2009 Daihatsu Copen

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

underseal covering all under floor components

Offside Front Headlamp not working on dipped beam in op head lamp (4.1.1 (a) (ii))

Offside Front Suspension rod ball joint dust cover no longer prevents the ingress of dirt suspension arm ball joint burst (5.3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Brake pipe corroded, covered in grease or other material all pipes covered (1.1.11 (c))

Nearside Front Coil spring corroded corroded at top (5.3.1 (b) (i))

Offside Front Coil spring corroded corroded (5.3.1 (b) (i))

underbody fully covered in body sealer

Brake performance unable to be tested (1.2.1 (g))

Nearside Brake pipe excessively corroded front to rear at rear (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Brake pipe leaking on a hydraulic braking system front to rear (1.1.11 (b) (ii)) DANGEROUS

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength shock absorber top mounting area (5.3.6 (a) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wheel arch holed (6.1.1 (c) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis leg forward of rear axle mounting point (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength shock absorber top mounting area (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brake pipe corroded, covered in grease or other material n/s & o/s pipes corroded (1.1.11 (c))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill at rear beam mounting point (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis leg at axle beam mounting point also inner sill holed (5.3.6 (a) (i))

Rear Brake pipe corroded, covered in grease or other material n/s & o/s pipes corroded (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Exhaust has a minor leak of exhaust gases joint (6.1.2 (a))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Tyre not fitted in accordance with side wall instructions (5.2.3 (i))

Offside Front Tyre not fitted in accordance with side wall instructions (5.2.3 (i))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Exhaust has a minor leak of exhaust gases joint (6.1.2 (a))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Brake disc significantly and obviously worn inner face (1.1.14 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Brake disc significantly and obviously worn inner face (1.1.14 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Engine management light on dash.

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Items removed from driver's view prior to test ()

Nearside Front Lower Ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

O/S/R tyre (worn on outer edge)

Offside Front Lower Ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Engine management light on dash.

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Items removed from driver's view prior to test ()

Nearside Front Lower Ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Nearside Headlamp aim too high (1.8)

O/S/R tyre (worn on outer edge)

Offside Front Lower Ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Outer Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Brake pipe excessively corroded front to rear (3.6.B.2c)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Inner Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

front inner brake pads wearing low?

both rear tyres getting low on inner edge.

front brake discs start to rust across inner braking surface.

front brake discs rusty inner surfaces

nsr tyre inner edge 3mm and feathered

osr tyre inner edge 3mm and feathered

Offside Front position lamp(s) not working (1.1.A.3b)

front brake discs rusty inner surfaces

nsr tyre inner edge 3mm and feathered

osr tyre inner edge 3mm and feathered

nsf tyre tread 2mm

osf tyre tread 2mm

Nearside Front Front position lamp(s) not working (1.1.A.3b)

nsf tyre tread 2mm

osf tyre tread 2mm

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Headlamp aim too far to the right (1.8)