2002 Jaguar X-type

Mil lamp on indicating engine fault

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting floor (6.2.2 (d) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Mil lamp on indicating engine fault

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre(s) incorrect because tyres with different aspect ratios are fitted on the same axle. (4.1.A.1a)

Nearside Rear Lower Trailing arm severely distorted (2.4.G.1)

Nearside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Outer Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Nearside Front Anti-roll bar ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Rear Rear position lamp(s) not working (1.1.A.3b)

Nearside Front Anti-roll bar ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Anti-roll bar ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)

eml on

Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Rear Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (4.1.E.2a)

Offside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (4.1.E.2a)

Offside Rear Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (4.1.E.2a)

Front brake disc slightly pitted (3.5.1h)

Rear Suspension weakened but no possibility of the body or a component fouling a road wheel (2.4.A.1b)