2002 Rover 25

Engine management light illuminated

Nearside Rear fog lamp lens defective which has no effect on emitted light (4.5.1 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Engine management light illuminated

Headlamp aim too low (4.1.2 (a))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear fog lamp lens defective which has no effect on emitted light (4.5.1 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Various corrosion to body panels

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Headlamp aim too low (4.1.2 (a))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Tyre worn close to legal limit/worn on edge both sides strongly advised (5.2.3 (e))

Nearside Front Power steering pipe/hose has slight seepage (2.1.5 (a))

Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill both sides (5.3.6 (a) (i))

Rear Outer Suspension component mounting repair covered in underseal sill both sides (5.3.6 (a) (i))

Offside Front Seat belt webbing slightly damaged or frayed driver (7.1.2 (b) (ii))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Rear Tyre slightly damaged/cracking or perishing both sides (5.2.3 (d) (ii))

x 2 front and x 2 rear wheel arches are corroded and inner sills

Nearside Front drive shaft outer gaiter deterioted

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front drive shaft outer gaiter deterioted

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

pin hole in n/s/cv boot / rear inner sills corroding

Nearside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Service brake: efficiency below requirements (3.7.B.7)

pin hole in n/s/cv boot / rear inner sills corroding

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Outer Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Outer Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)