2002 Vauxhall Vivaro

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Parking brake effort low

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Anti-roll bar ball joint likely to become detached nut missing (5.3.4 (a) (ii)) DANGEROUS

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Headlamp aim projected beam image is obviously incorrect bulb wrong (4.1.2 (c))

Offside Front Headlamp aim projected beam image is obviously incorrect bulb wrong (4.1.2 (c))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Front Suspension spring mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Brake load sensing valve linkage defective and function impaired missing (1.1.17 (a))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Body component damaged and likely to cause injury lens (6.2.1 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Front Suspension spring mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Engine mounting damaged but not to excess (6.1.8 (a) (i))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

both front flexi brake hoses insecure

both front out riggers badly corroded. not within 30cm of mounting points

both inner cv gaiters deteriorating

chips in windscreen within set limits

slight play in front struts top mountings

Brake pipe excessively corroded to n/s rear flexi brake hose (1.1.11 (c))

Front Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords inner wall (5.2.3 (d) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Headlamp aim too high (4.1.2 (a))

Offside Outer Track rod end ball joint has excessive play (2.1.3 (b) (i))

Rear Registration plate does not conform to the specified requirements (0.1 (d))

Engine mounting damaged but not to excess (6.1.8 (a) (i))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

both front flexi brake hoses insecure

both front out riggers badly corroded. not within 30cm of mounting points

both inner cv gaiters deteriorating

chips in windscreen within set limits

slight play in front struts top mountings

Nearside Front indicator faded

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

brake discs worn / corroded

engine warning lamp illuminated

front brakes give slightly fluctuating readings

surface cracks and perish marks in tyre walls

Front registration plate character(s) incorrectly spaced (6.3.4a)

Nearside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Nearside Front Upper Anti-roll bar linkage ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Offside Headlamp aim too high (1.8)

Rear registration plate character(s) incorrectly spaced (6.3.4a)

Windscreen washer provides insufficient washer liquid (8.2.3)

rear brake application uneven (3.7.B.2)

Nearside Front indicator faded

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

brake discs worn / corroded

engine warning lamp illuminated

front brakes give slightly fluctuating readings

parking brake could be better

surface cracks and perish marks in tyre walls

Front registration plate character(s) incorrectly spaced (6.3.4a)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside rear parking (secondary) brakes imbalanced (3.7.B.6b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Rear registration plate character(s) incorrectly spaced (6.3.4a)

Offside front brake fluctuating, but not excessively (3.7.B.3)

front brake discs in poor condition

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside Stop lamp not working (1.2.1b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside front brake fluctuating, but not excessively (3.7.B.3)

front brake discs in poor condition

Brakes imbalanced across an axle (3.7.B.5b)

Front registration plate character(s) laid out in an incorrect format (6.3.4f)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear registration plate character(s) laid out in an incorrect format (6.3.4f)

Offside Track rod end ball joint has excessive play (2.2.B.1f) DANGEROUS

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

drivers sunviser does notstay up

Front registration plate deteriorated (6.3.1d)

Hazard warning switch faulty (1.4.B.1d)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Direction indicator excessively deteriorated so that it is not visible from a reasonable distance (1.4.A.2e)

Offside Rear Stop lamp not working (1.2.1b)

Stop lamp not working (1.2.1b)

Track rod end ball joint has excessive play (2.2.B.1f)

drivers sunviser does notstay up

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front brake disc cracked (3.5.1h)

Nearside Front Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Rear brake caliper leaking (3.6.A.1)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Brake pad(s) wearing thin (3.5.1g)

Shock absorber has a slightly reduced damping effect (2.7.5)