2003 Mercedes-benz Vito

Lower Gearbox mounting defective ()

exhaust rubber broken

front no plate cracked

o/s/f inner wheel arch rusty

top engine mount bolt loose

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Horn not working (7.7 (a) (ii))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Rear fog lamp switch inoperative (4.5.3 (a) (ii))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Lower Gearbox mounting defective ()

exhaust rubber broken

front no plate cracked

o/s/f inner wheel arch rusty

top engine mount bolt loose

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

inner sills rusty / n/s/r tyre cracking

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Inner Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

inner sills rusty / o/s headlight loose / n/s/r tyre cracking

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement o/s n/s (2.4.G.2)

heavy oil leak

suspension rusty

underneath slight rust

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear fog lamp not working (1.3.2b)

Parking brake lever defective so that it cannot be satisfactorily operated (3.1.3c)

Parking brake: efficiency below requirements (3.7.B.7)

Rear fog lamp tell tale not working (1.3.1b)

Rear registration plate character(s) likely to be misread (6.3.4b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Stop lamp not working (1.2.1b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Brake load sensing valve linkage seized (3.6.E.3)

Registration plate lamp not working (1.1.C.1d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

front brake discs in poor condition

Centre Exhaust has part of the system excessively deteriorated (7.1.1a)

Parking brake: efficiency below requirements (3.7.B.7)

rear brake application uneven (3.7.B.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)