2016 Mercedes-benz Vito

Offside Wheel/tyre protruding beyond wheel arch

Steering rack has slight free play detected at steering wheel (2.3 (a) (i))

Nearside Body component damaged and likely to cause injury (6.2.1 (a) (i))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Parking brake lever defective so that it cannot be satisfactorily operated (1.1.6 (d))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Wheel/tyre protruding beyond wheel arch

Steering rack has slight free play detected at steering wheel (2.3 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Windscreen wiper blade defective (3.4 (b) (i))

Rear Brake disc worn, but not excessively both side (1.1.14 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Outer Tyre worn close to legal limit/worn on edge both side (5.2.3 (e))

Nearside Rear Nail in tyre

all 4 disc worn strong advisory

ALL FOUR DISC STARTING TO WEAR

BOTH FRONT TYRES CLOSE TO LIMIT

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Front Side repeater not working (4.4.1 (a) (ii))

Brake pedal wearing smooth (1.1.2 (c))

Nearside Front tyre worn inner and outer edge

Play in steering rack inner joint(s) Strong advice

Rear Brake disc worn, but not excessively Strong advice (1.1.14 (a) (i))

engine undertray fitted obscuring components

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))