2007 Smart (mcc) Fortwo Coupe

Nearside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Windscreen Minor Chip Marks Not Affecting Driver View

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Windscreen Minor Chip Marks Not Affecting Driver View

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Fuel cap/sealing device ineffective fuel cap seal split (6.1.3 (b) (i))

Horn not working (7.7 (a) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Windscreen in an unacceptable condition multiple chips in zone A bigger than 10mm (3.2 (c) (i))

Offside Headlamp aim too low (4.1.2 (a))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

engine covers and undertrays fitted obscuring components

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Gearbox mounting defective ()

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Stop lamp not working N/S + O/S (1.2.1b)

Gearbox mounting defective ()

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Offside Stop lamp not working (1.2.1b)

Offside Front suspension has excessive movement at a wishbone pin or bush (2.5.A.1c)

Offside Headlamp not working on dipped beam (1.7.5a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Suspension arm rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

fuel cap sealing washer split (MOT requirements met at time of test)

Engine covers fitted obscuring some components in the engine bay

Front Brake pad(s) wearing thin (3.5.1g)

Under-trays fitted obscuring some underside components