1988 Toyota MR2

Front Brake pipe corroded, covered in grease or other material both front (1.1.11 (c))

Nearside Front seat removed

Rear Brake pipe corroded, covered in grease or other material both rear (1.1.11 (c))

Registration plate deteriorated but not likely to be misread both (0.1 (b))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Oil leaking excessively from engine (8.4.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected floor (5.3.6 (a) (ii)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected inner sill (5.3.6 (a) (ii)) DANGEROUS

Offside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected floor (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected floor (5.3.6 (a) (ii)) DANGEROUS

Front Brake pipe corroded, covered in grease or other material both front (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material all rear (1.1.11 (c))

Registration plate deteriorated but not likely to be misread both front and rear (0.1 (b))

sill covers fitted

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front floor corroded

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Inner Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Inner Front Vehicle structure has an inadequate repair, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear fog lamp not working (1.3.2b)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Parking brake lever has little reserve travel (3.1.6b)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Front registration plate missing (6.3.1a)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Headlamp aim not tested (1.8.A.1c)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

both front tyres wearing low

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Oil leak

general body and underside of vehicle corrosion

parking brake travel long

plastic sill covers fitted

Front registration plate missing (6.3.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

plastic sill covers fitted

Both front brake pipes slightly corroded

Both rear tyres low

Both sills corroded

Front Exhaust has a major leak of exhaust gases (7.1.2)

Front registration plate missing (6.3.1a)

Both front brake pipes slightly corroded

Both rear tyres low

Both sills corroded

Nearside Inner Rear Tie bar/rod has excessive play in a pin/bush (2.4.G.2)

Offside Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Rear Tie bar/rod severely distorted (2.4.G.1)