2012 Audi A6

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Front Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii)) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. BRAKE JUDDER FRONT (1.2.2 (a) (i))

Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both linkage rubber perished (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake pad warning light illuminated

Central Exhaust mounting defective Clamps broken (6.1.2 (a))

Rear Registration plate does not conform to the specified requirements Incorrect spacing (0.1 (d))

Brake pad warning light illuminated

Central Exhaust mounting defective Clamps broken (6.1.2 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Both centre exhaust joining sleeves corroded /in poor condition

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Tyre pressure monitoring system malfunctioning or obviously inoperative (5.2.3 (h))

Both centre exhaust joining sleeves corroded /in poor condition

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

under trays fitted not allowing full inspection