1985 Saab 90

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Exhaust emissions hydrocarbon content excessive (8.2.1.2 (b))

Nearside Front Steering linkage ball joint has excessive play (2.1.3 (b) (i))

Offside Front Steering linkage ball joint has excessive play (2.1.3 (b) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Suspension component mounting prescribed area damaged but not considered excessive undersealed (5.3.6 (a) (i))

Front advise oil leak

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Steering rack gaiter missing or no longer prevents the ingress of dirt Burst (2.1.3 (g) (ii))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Both Rear Shocker Casings Corroded

Car Under Sealed

Nearside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Inner Arch (6.2.2 (d) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside front parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

underneath vehicle is heavily undersealed

Oil leak

Offside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

both sides front suspension mount points have been coverd in underseal and repaird

Nearside Rear Brake hose ferrule excessively corroded (3.6.B.4e)

Offside Rear Brake hose ferrule excessively corroded (3.6.B.4e)

Parking brake: efficiency below requirements (3.7.B.7)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside front parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)