1984 Ford Capri

fresh under seal to floor

Front Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

general body and chassie surface corrosion

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced chassie rail (6.1.1 (c) (i))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Brake hose excessively twisted (1.1.12 (b) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

general body and chassie surface corrosion

Brake performance not tested brake pipe burst (1.2.1 (g))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Nearside Front Floor excessively deteriorated (6.2.4 (a) (i))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor pan (6.1.1 (c) (i))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis rail (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring mount 3 places (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength tie rod mount (5.3.6 (a) (i))

Offside Front Floor excessively deteriorated (6.2.4 (a) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor pan (6.1.1 (c) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength lower arm mount (5.3.6 (a) (i))

Offside Rear Brake pipe excessively corroded burst during brake test (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength tie rod mount (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced sil (7.1.1 (a) (i))

Tyre fouling a part of the vehicle exhaust fouling tyre (5.2.3 (f))

Windscreen washer not working (3.5 (a))

Fuel tank slightly loose (6.1.3 (a) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front slight corrosion by head light

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Exhaust noisy (7.1.4)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Front Oil leak ()

Nearside Front Body has slight corrosion Floor (6.1.B.2)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Offside Front wheel bearing has slight play (2.5.A.3c)

Rear Oil leak ()

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust noisy (7.1.4)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Front Oil leak ()

Nearside Front Body has slight corrosion Floor (6.1.B.2)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Offside Front wheel bearing has slight play (2.5.A.3c)

Rear Oil leak ()

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded Inner sill (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded Inner wing (2.4.A.3)

Offside Headlamp aim too low (1.8)

Offside Rear Suspension component mounting prescribed area is excessively corroded Inner sill (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded Outer sill (2.4.A.3)

Rear fog lamp tell tale not working (1.3.1b)

rear parking (secondary) brakes imbalanced (3.7.B.6b)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive a pillar corroded behind wing (2.4.A.3)

Nearside Rear Anti-roll bar worn but not seriously weakened bush (2.4.G.1)

Nearside outer sill corroded

Offside Front outer wing top corroded

Offside outer sill corroded

Rear Anti-roll bar corroded but not seriously weakened (2.4.G.1)

Suspension component mounting prescribed area is corroded but not considered excessive all underside of vehicle corroding (2.4.A.3)

Nearside Front Anti-roll bar linkage missing split pin missing to track control arm (2.4.G.1)

Nearside Front Suspension component mounting prescribed area is excessively corroded a pillar near wing (2.4.A.3)

Nearside Rear Anti-roll bar has excessive play in a pin/bush anti roll bush outer (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded front spring mounting (2.4.A.3)

Offside Front Anti-roll bar linkage missing spit pin to track control arm (2.4.G.1)

Offside Rear Braking system leaking oil (3.6.A.1)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Suspension component mounting prescribed area is corroded but not considered excessive all underside of vehicle corroding (2.4.A.3)

Complete under side corodded.

Nearside Front Body has slight corrosion (6.1.B.2)

Nearside Front Rear wheel bearing has slight play (2.6.2)

Offside Front Body has slight corrosion (6.1.B.2)

Oil leak

Rear exhaust systerm deteriorated.

Nearside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Nearside Rear wheel bearing rough when rotated (2.6.1)

Offside Front Steering arm has relative movement at its fixings (2.2.B.1h)

Offside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear wheel bearing rough when rotated (2.6.1)

Complete under side corodded.

Nearside Front Body has slight corrosion (6.1.B.2)

Nearside Front Rear wheel bearing has slight play (2.6.2)

Offside Front Body has slight corrosion (6.1.B.2)

Oil leak

Rear exhaust systerm deteriorated.

Front registration plate delaminated but not likely to be misread (6.3.1d)

both floor pans corroded

excessive surface corrosion all around vehicle

n/s/r bump stop missing

rear diff leaking

slight noise from both rear wheel bearings

Battery insecure (1.9.1)

Offside Front Headlamp aim too low (1.8)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

both floor pans corrored

excessive surface corrossion all aound vehicle

nearside rear bump stop missing

radiator excessive corrored

rear diff leaking

slight noise from both rear wheel bearings

Nearside Stop lamp not working (1.2.1b)

Offside rear brake recording little or no effort (3.7.B.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Indicator switch faulty (1.4.A.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Fuel cap/sealing device does not fasten securely by positive means (7.2.4b)

Horn not working (1.6.2a)