2004 Honda Civic

Integral body structure is deformed and structural rigidity is significantly reduced front to rear corroded and contains corrosion holes on offside (6.1.1 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement D bush (5.3.4 (a) (i))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Shock absorbers has a reduced damping effect (5.3.2 (d))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced general underbody rust (6.1.1 (c) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced general underbody rust (6.1.1 (c) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits sports cat fitted may effect emmisions (8.2.1.2 (b))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Headlamp light intensity severely reduced affected by another light (4.1.4 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

EMI light on intermittent

Exhaust has a minor leak of exhaust gases down pipe (6.1.2 (a))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

EMI light on intermittent

Exhaust has a minor leak of exhaust gases down pipe (6.1.2 (a))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Fuel cap/sealing device missing (6.1.3 (b) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Emissions not tested exhaust blowing on every joint (8.2.1.2 (d))

Exhaust system insecure fouling rear anti roll bar (6.1.2 (a))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sil all along (5.3.6 (a) (i))

Nearside Front Suspension arm ball joint likely to become detached locking device missing (5.3.4 (a) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside rear brake recording little or no effort (3.7.B.5a)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Anti-roll bar linkage insecure (2.4.G.1)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Registration plate lamp not working (1.1.C.1d)

general under body corrosion

Nearside Front Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)