2004 Subaru Legacy

Front Oil leaking excessively from transmission (8.4.1 (a) (i))

Nearside Front Inner Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill / two holes (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Front Brake pipe corroded, covered in grease or other material Both (1.1.11 (c))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Both rear (5.3.4 (a) (i))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Inner Brake pads not seen

Offside Rear Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Parking brake has little reserve travel

Play in steering rack inner joint(s) ()

Power steering fluid level below minimum (2.1.5 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material Both (1.1.11 (c))

Rear Suspension arm pin or bush worn but not resulting in excessive movement Both trailing arm bushes (5.3.4 (a) (i))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill / two holes (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Brake pipe corroded, covered in grease or other material Both (1.1.11 (c))

Front Headlamp lens slightly defective Both (4.1.1 (b) (i))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Both rear (5.3.4 (a) (i))

Inner Brake pads not seen

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Suspension arm pin or bush worn but not resulting in excessive movement Both trailing arm bushes (5.3.4 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

O/S/R TYRE WORN INNER EDGE

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength INNER SILL (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength OUTER SILL (5.3.6 (a) (i))

O/S/R TYRE WORN INNER EDGE

REAR SUB-FRAME CORRODED

REAR TYRES WORN INNER EDGE

exhaust rusty at rear

Nearside Stop lamp not working (1.2.1b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Service brake juddering slightly (3.7.C.2)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Rear coil spring incomplete (2.4.C.1a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)