2002 Honda NSR125

Nearside Handlebar deformed but serviceable (2.2.1 (c) (i))

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Rear Wheel bearing has slight play (5.1.3 (a) (i))

Headlamp not working on dipped beam (4.1.1 (a) (ii))

Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Handlebar deformed but serviceable (2.2.1 (c) (i))

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Rear Wheel bearing has slight play (5.1.3 (a) (i))

Fairings insecure but not likely to impede the steering (2.1.2e)

Front suspension assembly slightly misaligned (2.3.1)

Headlamp aim too high (1.6)

Offside Steering control has Insufficient clearance at full lock affecting the riders grasp of handlebars (2.1.2b)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

different indicator fitted to o/s/f and different flash rate but not excessive

Fairings insecure but not likely to impede the steering (2.1.2e)

Front suspension assembly slightly misaligned (2.3.1)

different indicator fitted to o/s/f and different flash rate but not excessive

off side rear position bulb not illuminating

Drive chain excessively loose (6.2.1d)

Drive chain worn to excess (6.2.1e)

Front Brake pad(s) (sintered type) less than 1.0mm thick (3.2A1f(ii))

Nearside Handlebar handgrip not secure to handlebars. (2.1.1c)

Nearside Motorcycle structure excessively damaged (6.1.1a)

Rear Brake pad(s) close to minimum limit (3.2A1f(ii))

Rear Drive chain sprocket slightly worn (6.2.1e)

off side rear position bulb not illuminating.

Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.2a(i))

Rear reflector on motorcycle missing (1.4.1)

Steering movement excessively rough with the wheel raised (2.2.1b)

Throttle operating incorrectly (6.2.1f)

Drive chain excessively loose (6.2.1d) DANGEROUS

Rear Drive chain sprocket slightly worn (6.2.1e)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))