2002 Ford Ka

Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Exhaust has a major leak of exhaust gases front faxable pipe (6.1.2 (a))

Nearside Front Shock absorbers has an excessively worn bush (5.3.2 (c))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Offside Front Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Brake pipe corroded, covered in grease or other material near the fuel tank (1.1.11 (c))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Steering linkage ball joint has slight play tie bar (2.1.3 (b) (i))

Offside Front wing corroded and loose

Offside Rear q panel corrosion near petrol flap

corrosion under vehicle

Exhaust has a minor leak of exhaust gases Flexi-pipe (6.1.2 (a))

Offside Front Outer Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Rear axle bushes worn o/s & n/s

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases Flexi-pipe (6.1.2 (a))

Offside Front Outer Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Rear axle bushes worn o/s & n/s

Nearside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Body has slight corrosion (6.1.B.2)

Offside Rear Body has slight corrosion (6.1.B.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Inner Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

fuel filler neck corroded on seal

offside mirror taped secure

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Nearside Inner Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

fuel filler neck corroded on seal

offside mirror taped secure

both rear tyres slightly perished centre exhaust slightly corroded

centre exhaust system corroding

nearside rear tyre outer wall deteriating

NEAR SIDE AND OFF SIDE FRONT TYRES BOTH SCRUBBING ON OTER EDGES OF TREAD AREAS.

Nearside Rear coil spring fractured (2.4.C.1a)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Nearside Front Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)

Offside Front Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)