2002 MG Zr

Rear bumper insecure

Nearside Front wheel bearing has slight play (2.5.A.3c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Brake pedal anti-slip provision incomplete (3.3.A.1b)

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Headlamp aim too low (1.8)

Nearside Rear position lamp(s) insecure (1.1.A.3a)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Tie bar/rod attachment bracket/mounting bolt missing (2.4.G.1)

Offside Headlamp insecure (1.7.3)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

registration plate font not substantially similar to the prescribed font (6.3.4d)

Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

Nearside Front wheel bearing has slight play (2.5.A.3c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Rear bumper insecure

Offside Front Lower Ball joint has slight play (2.2.B.1f)

Centre Rear Seat belt retracting mechanism defective (5.2.5b)

Front position lamp(s) not working (1.1.A.3b)

Headlamp incorrect colour (1.7.5b)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Offside Front Lower Ball joint has slight play (2.2.B.1f)

interior mirror missing

vehicle has accident damage

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust mounting missing (7.1.1b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp insecure (1.7.3)

Offside Front Subframe mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Front Subframe mounting prescribed area is severely distorted (2.4.A.3)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside front brake application uneven (3.7.B.2)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Brake pad(s) wearing thin (3.5.1g)

body filler on offside front floor

interior mirror missing

vehicle has accident damage

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Horn not loud enough to be heard by another road user (1.6.2b)

Nearside Headlamp aim too low (1.8)

Nearside Outer Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Headlamp aim too low (1.8)

Rear Bootlid cannot be secured in the closed position (6.4.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Outer Front Brake pad(s) wearing thin (3.5.1g)

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Nearside Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)