2003 Ford Focus

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Brake pipe excessively corroded also under bonnet (1.1.11 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Brake pipe excessively corroded also under bonnet (1.1.11 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Rear Exhaust system insecure (6.1.2 (a))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Anti-roll bar linkage attachment bracket/mounting fractured (5.3.3 (b) (ii)) DANGEROUS

Fluid leak, but not excessive (8.4.1 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement front bush (5.3.4 (a) (i))

Speedometer not sufficiently illuminated (7.8 (c) (i))

Emissions not tested (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Brake pipe corroded, covered in grease or other material All (1.1.11 (c))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement REAR arm bushes (5.3.4 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material All (1.1.11 (c))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement REAR arm bushes (5.3.4 (a) (i))

Tyre slightly damaged/cracking or perishing both rears (5.2.3 (d) (ii))

Tyre worn close to legal limit/worn on edge both fronts (5.2.3 (e))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting nsr oouter sill (6.2.2 (d) (i))

Upper Stop lamp(s) not working (4.3.1 (a) (ii))

Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

Rear Exhaust shield missing where fitted as original equipment creating a risk of fire (6.1.3 (e)) DANGEROUS

Tyre slightly damaged/cracking or perishing both rears (5.2.3 (d) (ii))

Tyre worn close to legal limit/worn on edge both fronts (5.2.3 (e))

Brake pipe slightly corroded (3.6.B.2c)

Play in steering rack inner joint(s) ()

Parking brake lever has little reserve travel (3.1.6b)

Play in steering rack inner joint(s)

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

Parking brake lever has little reserve travel (3.1.6b)

Play in steering rack inner joint(s)

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

near side rear tyre rubber cracking at edges of tread

off side front tyre rubber cracking at edges of tread

off side rear tyre rubber cracking at edges of tread

brake disc slightly pitted (3.5.1h)

Headlamp not in good working order adversely affecting beam image (1.2.4a)

Windscreen washer provides insufficient washer liquid (8.2.3)