2003 Ford Transit

Emissions not tested due to oil level to be below minimum level (8.2.2.2 (e))

Fuel tank leaking (6.1.3 (b) (i))

Nearside Front Hydraulic brake calliper insecurely mounted caliper bolt showing movement (1.1.16 (c) (i))

Nearside Front Service brake excessively fluctuating (1.2.1 (e))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength near spring front mounting (5.3.6 (a) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is inadequately repaired inner wheel arch and corrosion (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is inadequately repaired inner wheel arch and corrosion (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is inadequately repaired chassis (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is inadequately repaired chassis at brake limiter mounting (5.3.6 (a) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

There has been extensive welding carried out on this vehicle out in and outside of prescribed areas and is in poor condition.

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Windscreen washer not working (3.5 (a))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

front brake balance only just met requirements

previous welding repairs covered in protective sealant , not fully visible

slight oil leak

Nearside Front Body has a sharp edge caused by corrosion wheel arch (6.1.C.1)

Nearside Front Suspension component mounting prescribed area is excessively corroded inner wing strut mount area (2.4.A.3)

Nearside Front front brake binding (3.7.B.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded chassis near load valve (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded load area to inner arch (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded outer sill area (2.4.A.3)

Offside Front Body has a sharp edge caused by corrosion wheel arch (6.1.C.1)

Offside Front Suspension component mounting prescribed area is excessively corroded inner wing strut mount area (2.4.A.3)

Offside Front Wheel nut(s) missing one (4.2.A.1e)

Offside Front front brake binding (3.7.B.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded chassis near bump stop area (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded load area to wheel arch (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Offside Front Nail in tyre ()

Offside Front Tyre worn close to the legal limit (4.1.E.1)

major engine oil leak

Nearside Front Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Vehicle structure has slight corrosion under body (6.1.B.2)

both front suspension arm rear bushes deteriorated

nearside front tyre inner and outer edges worn

oil leak

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner sill (6.1.B.2)

Nearside Front Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Vehicle structure has slight corrosion under body (6.1.B.2)

both front suspension arm rear bushes deteriorated

nearside front tyre inner and outer edges worn

oil leak

Nearside Rear Vehicle structure has slight corrosion (6.1.B.2)

Offside Rear Vehicle structure has slight corrosion (6.1.B.2)

Oil leak

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

nearside front jacking point damaged

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Nearside Rear Vehicle structure has slight corrosion (6.1.B.2)

Offside Rear Vehicle structure has slight corrosion (6.1.B.2)

Oil leak

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

nearside front jacking point damaged

nearside front outer sill corroded

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Vehicle structure has slight corrosion (6.1.B.2)

Offside Rear Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Lower Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Nearside Headlamp aim too low and too far to the right. (1.8)

Offside Headlamp aim too low and too far to the right. (1.8)

Offside Outer Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front Shock absorber has a light misting of oil (2.7.3)