2003 MG Zr

Offside Headlamp aim too low (4.1.2 (a))

Nearside Headlamp aim too high (4.1.2 (a))

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear Exhaust system not adequately supported (7.1.1)

Nail in nearside rear tyre

Nearside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Nearside Headlamp aim too high (1.8)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Headlamp aim too high (1.8)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

front brake pads worn

Brake master cylinder fluid close to minimum level (3.6.G.1e)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Headlamp aim too low (1.8)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Headlamp aim too low (1.8)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Rear Exhaust has a major leak of exhaust gases (7.1.2)