MOT Status
ValidMileage
121,250 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))
corrosion all over underbody
underseal applied all over underbody
Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))
Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS
underseal applied all over underbody
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))
corrosion all over underbody
Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Offside Front Coil spring corroded (5.3.1 (b) (i))
Rear Coil spring corroded both side (5.3.1 (b) (i))
Rear Shock absorbers has light misting of oil both side (5.3.2 (b))
Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))
Rear Suspension component corroded but not seriously weakened (5.3.3 (b) (i))
Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sills
Front Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))
Front Lower Suspension component mounting prescribed area is corroded but not considered excessive cross member (5.3.6 (a) (i))
Rear Brake pipe corroded, covered in grease or other material both ends (1.1.11 (c))
Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))
sill covers fitted not allowing full inspection
underbody heavily undersealed
Front Coil spring corroded both (5.3.1 (b) (i))
Front Shock absorbers has slight external damage to the casing both corroded (5.3.2 (b))
Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))
Rear Brake hose has slight corrosion to ferrule both (1.1.12 (f) (i))
Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))
Rear Sub-frame corroded but not seriously weakened axle slightly corroded (5.3.3 (b) (i))
underbody corrosion
Front Brake hose ferrule excessively corroded both (1.1.12 (f) (i))
Front Lower Suspension arm insecurely attached both (5.3.3 (a) (i))
Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))
Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))
Offside Rear Brake pipe excessively corroded (1.1.11 (c))
Rear Service brake excessively binding (1.2.1 (f))
Front Coil spring corroded both (5.3.1 (b) (i))
Front Shock absorbers has slight external damage to the casing both corroded (5.3.2 (b))
Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))
Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))
Rear Brake hose has slight corrosion to ferrule both (1.1.12 (f) (i))
Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sills (5.3.6 (a) (i))
Rear Sub-frame corroded but not seriously weakened axle slightly corroded (5.3.3 (b) (i))
underbody corrosion
Front Shock absorbers has slight external damage to the casing and rear (5.3.2 (b))
Front both suspension arms corrded
Nearside Rear Brake pipe corroded, covered in grease or other material main (1.1.11 (c))
Offside Rear Brake pipe corroded, covered in grease or other material main (1.1.11 (c))
under body corrison all over
Front Shock absorbers has slight external damage to the casing and rear corroded (5.3.2 (b))
Front Suspension arm corroded but not seriously weakened both (5.3.3 (b) (i))
outer sills covered not allowing full insp
underbody corrosion all over //both rear inner sills corroded not excessive
Front Brake hose has slight corrosion to ferrules both sides (3.6.B.4e)
Offside Rear Body has slight corrosion chassis (6.1.B.2)
Offside Rear Brake pipe slightly corroded from brake hose (3.6.B.2c)
corrosion also found on wishbone both sides, o/s/f calliper and both front drive shafts.
Headlamp aim beam image obviously incorrect both sides (1.8.A.1b)
Nearside front brake binding (3.7.B.1)
Offside front brake binding (3.7.B.1)
Offside rear brake excessively fluctuating (3.7.B.3)
Parking brake lever has no reserve travel (3.1.6b)
Front Brake hose has slight corrosion to ferrules both sides (3.6.B.4e)
Nearside rear brake fluctuating, but not excessively (3.7.B.3)
Offside Rear Body has slight corrosion chassis (6.1.B.2)
Offside Rear Brake pipe slightly corroded from brake hose (3.6.B.2c)
corrosion also found on wishbone both sides, o/s/f calliper and both front drive shafts.
Nearside Front Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)
Offside Front Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)
Engine covers fitted obscuring some components in the engine bay
Nearside front brake fluctuating, but not excessively (3.7.B.3)
Nearside rear parking (secondary) brake grabbing slightly (3.7.B.6b)
Offside front brake fluctuating, but not excessively (3.7.B.3)
Offside rear parking (secondary) brake grabbing slightly (3.7.B.6b)
Under-trays fitted obscuring some underside components
Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Parking brake lever has little reserve travel (3.1.6b)
Rear Brake pad(s) wearing thin (3.5.1g)
Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Rear registration plate faded but not likely to be misread (6.3.1d)
front no.plate cracked
Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)
Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Parking brake lever has little reserve travel (3.1.6b)
Rear Brake pad(s) wearing thin (3.5.1g)
Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Rear registration plate faded but not likely to be misread (6.3.1d)
front no.plate cracked
Nearside Front Tyre worn close to the legal limit (4.1.E.1)
Offside Front Tyre worn close to the legal limit (4.1.E.1)
Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Nearside Front Tyre worn close to the legal limit (4.1.E.1)
Offside Front Tyre worn close to the legal limit (4.1.E.1)
Nearside Rear Tyre worn close to the legal limit (4.1.E.1)
Offside Tyre worn close to the legal limit (4.1.E.1)
Rear brake disc slightly pitted (3.5.1h)
both rear tyres wearing on inner edges
Offside Front wheel bearing rough when rotated (2.5.A.2)
How Reliable is the Toyota Corolla?
Based on 4,239,724 MOT tests across 329,089 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
BD04 CFM is a 2004 Toyota Corolla in Grey with a 1,398cc petrol engine. This vehicle has been through 25 MOT tests with a personal pass rate of 76%.
Across all 2004 Toyota Corolla models, the average MOT pass rate is 76.5% with a typical mileage of 70,639 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Toyota Corolla fails its MOT is tyre tread depth below requirements of 1.6mm, accounting for 151,978 recorded failures. If you're considering buying BD04 CFM, it's worth having these areas checked by a mechanic before committing.
The Toyota Corolla typically stays on UK roads for around 36 years. At 22 years old, this Toyota Corolla is well into its expected lifespan but still has years ahead.
Frequently Asked Questions
How do I check the history of BD04 CFM?
You can check the full history of BD04 CFM by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was BD04 CFM registered?
BD04 CFM is a 2004 Toyota Corolla, first registered on 24 April 2004.
Is BD04 CFM safe to buy?
The MOT history for BD04 CFM shows 25 tests with a 76% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does BD04 CFM have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on BD04 CFM. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.