2006 Subaru Impreza

Brake hose has slight corrosion to ferrule all (1.1.12 (f) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Central Exhaust mounting defective (6.1.2 (a))

Front Coil spring corroded both (5.3.1 (b) (i))

Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Front Shock absorbers has a reduced damping effect both sides , heavily corroded (5.3.2 (d))

Offside Rear level sensor arm broken

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Shock absorbers has a reduced damping effect both sides heavily corroded (5.3.2 (d))

Rear Suspension arm corroded but not seriously weakened both trailing arms (5.3.3 (b) (i))

underbody sealed

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre slightly damaged Knick in sidewall (5.2.3 (d) (ii))

underbody sealed

Front Both front sill jacking points are damaged

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords Outer sidewall (5.2.3 (d) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner sill prescribed area trailing arm mounting. Damaged and further corrosion to small hole. (5.3.6 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Position lamp not working both side lights (4.2.1 (a))

Front Tyre tread depth below requirements of 1.6mm both (5.2.3 (e))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Brake pipe excessively corroded to flexi (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front tyre wearing on inner edge

Offside Front tyre wearing on inner edge

Windscreen has damage to an area less than a 10mm circle within zone 'A' stone chip (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' stone chip (8.3.1d)

engine management lamp illuminated

Offside Rear Brake pipe slightly corroded brake pipes to load valve (3.6.B.2c)

engine management lamp illuminated

rear diff has oil leak

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

wiper blades perishing ends splitting

Front Brake pad(s) wearing thin (3.5.1g)

Inner Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.C.1b)

Service brake: efficiency below requirements (3.7.C.1a)

Unable to test brakes as rear pads worn out.