2007 Land Rover Range Rover

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component corroded but not seriously weakened both side (5.3.3 (b) (i))

Nearside Rear Suspension component pin or bush slightly worn lower hub bush (5.3.4 (a) (i))

Rear Sub-frame pin or bush worn but not resulting in excessive movement all 4 bushes (5.3.4 (a) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Front Brake lining(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Suspension component pin or bush slightly worn lower hub bush (5.3.4 (a) (i))

Rear Sub-frame pin or bush worn but not resulting in excessive movement all 4 bushes (5.3.4 (a) (i))

Spare tyre defective ()

rear exhaust heat shield insecure

Nearside Rear Lower Suspension component pin or bush slightly worn hub bush (5.3.4 (a) (i))

Nearside Front Lower Suspension arm pin or bush excessively worn front (5.3.4 (a) (i))

Offside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Lower Suspension component pin or bush slightly worn hub bush (5.3.4 (a) (i))

Nearside Front Tyre slightly damaged side wall (5.2.3 (d) (ii))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre slightly damaged side wall (5.2.3 (d) (ii))

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

n/s/r inner tyre wall bulged

play in o/s/r bottom hub bush

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)

both rear lower hub bushes slight play

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

nsf tyre wearing on inner edge

rear lower rose joints, both sides, have slight play

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

rear lower rose joints, both sides, have slight play