2008 Nissan Navara

Central Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Rear Lower wheel arches rusty nearside and offside

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis , inside and outside (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength next to leaf spring mount points (5.3.6 (a) (i))

Offside Driver's seat fore and aft adjustment mechanism not functioning as intended. (6.2.5 (b) (i))

Offside Rear Brake load sensing valve linkage defective and function impaired covered in mud , not moving due to this. (1.1.17 (a))

Rear Brake pipe excessively corroded nearside and offside. (1.1.11 (c))

Central Upper Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Rear nearside and offside wheel arches rusty

Offside Rear chassis slightly rusty.

Front Position lamp not working both (4.2.1 (a) (ii))

Horn not working (7.7 (a))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Lower Suspension component ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Obligatory indirect vision device does not provide a view to the rear (3.3 (c))

Windscreen washer not working (3.5 (a))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Brake pad(s) wearing thin front and rear (1.1.13 (a) (ii))

Prop shaft joint worn, but not excessively front prop rear u/j (6.1.7 (c) (i))

Rear Exhaust has a minor leak of exhaust gases silencer (6.1.2 (a))

Rear Exhaust mounting defective silencer (6.1.2 (a))

Offside Side repeater not working (4.4.1 (a) (ii))

Prop shaft joint worn, but not excessively front prop rear u/j (6.1.7 (c) (i))

Rear Exhaust has a minor leak of exhaust gases silencer (6.1.2 (a))

Rear Exhaust mounting defective silencer (6.1.2 (a))

Central Exhaust has a minor leak of exhaust gases silencer (6.1.2 (a))

Offside Obligatory mirror slightly damaged (3.3 (b) (i))

Prop shaft joint worn, but not excessively front propshaft rear u/j (6.1.7 (c) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

bonnet cable stretched advise replacement.

front anti roll bar D bushes worn.

front anti roll bar link ball joint dust covers starting to split.

front brake discs rusty lip.

slight oil leak.

front brake discs rusty lip.

stone chip in centre of front screen.

various brake pipes signs of corrosion.

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

front brake discs rusty lip.

stone chip in centre of front screen.

various brake pipes signs of corrosion.

Nearside Front brake disc worn, pitted or scored, but not seriously weakened inner face (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened inner face (3.5.1i)

Offside Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)