2013 Hyundai I10

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Windscreen washer not working (3.5 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear facing bush perished (5.3.4 (a) (i))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced Axle mounting area corroded (6.1.1 (c) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear facing bush perished (5.3.4 (a) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced Axle mounting area corroded (6.1.1 (c) (i))

Nearside Front Brake pipe excessively corroded End section just as it meets flexible brake hose. (1.1.11 (c))

Nearside Rear Brake pipe excessively corroded End section just as it meets flexible brake hose. (1.1.11 (c))

Offside Front Brake pipe excessively corroded End section just as it meets flexible brake hose. (1.1.11 (c))

Offside Rear Brake pipe excessively corroded End section just as it meets flexible brake hose. (1.1.11 (c))

Offside Rear Brake pipe excessively corroded Short brake pipe from flexible brake hose to wheel slave cylinder. (1.1.11 (c))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Lower arm rear facing bush. (5.3.4 (a) (i))

Nearside Front Tyre slightly damaged/cracking or perishing tyre is also low on 3mm (5.2.3 (d) (ii))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced Axle mounting sections are corroded. (6.1.1 (c) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Tyre slightly damaged/cracking or perishing Tyre is also low on 3mm (5.2.3 (d) (ii))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced Axle mounting sections are corroded. (6.1.1 (c) (i))

Suspension arm pin or bush worn but not resulting in excessive movement Lower arm rear facing bush. (5.3.4 (a) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Exhaust system corded

Exhaust system corded

Offside Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake slack adjuster advise adjustment (1.1.18 (a))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))