2004 Ford Ranger

Brake performance unable to be tested Brake pipe failed during brake test (1.2.1 (g))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Brake pipe excessively corroded Under drivers footwell (1.1.11 (c))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting Chassis cross member heavily corroded (6.1.6 (i) (i))

Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Drivers footwell rotten and holed (6.2.2 (d) (i))

Offside Brake pipe leaking on a hydraulic braking system Pipe burst and leaking fluid (mounted to chassis rail behind fuel tank) (1.1.11 (b) (ii)) DANGEROUS

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides - split (5.3.4 (a) (i))

Front Suspension arm ball joint dust cover severely deteriorated Both sides (5.3.4 (b) (i))

Nearside Front Upper Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Screw in inner edge

Offside Front Bottom ball joint nut has no securing split pin fitted (castellated nut)

Offside Front Brake pipe corroded, covered in grease or other material Inner arch to caliper flexi (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge Worn on outer edge (5.2.3 (e))

Offside Front track rod end nut has no securing split pin fitted (castellated nut)

Offside Fuel Pipe/s corroded Under drivers footwell ()

Offside Rear Brake pipe corroded, covered in grease or other material Pipe from load sensing valve to axle flexi corroded. (1.1.11 (c))

Unable to conduct brake pressure testing of components due to brake pipe failure

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Nearside Front Nail in tyre ()

Rear Direction indicator slightly discoloured (1.4.A.2f)

exhust rubber mount missing

Rear Exhaust system not adequately supported (7.1.1)

Nearside Front position lamp(s) incorrect colour (1.1.A.3e)

Offside Front position lamp(s) incorrect colour (1.1.A.3e)