2005 Mazda 6

Fuel Pipe/s corroded ()

Integral body structure is corroded but structural rigidity is not significantly reduced sills to floorpans (6.1.1 (c) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Lower Suspension arm ball joint excessively worn to rear (5.3.4 (a) (i))

Fuel Pipe/s corroded ()

Integral body structure is corroded but structural rigidity is not significantly reduced sills to floorpans (6.1.1 (c) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Suspension component mounting repair covered in underseal both side sills rear (5.3.6 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Brake hose excessively chafed (1.1.12 (b) (ii))

Offside Front Brake hose excessively twisted (1.1.12 (b) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Rear Brakes imbalanced across an axle 33% (1.2.1 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Seat belt buckle missing (7.1.2 (d))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Registration plate lamp not working (1.1.C.1d)

O/S/R WHHEL ARCH AREA HAS DAMAGE