2008 Iveco Daily 35S12 Mwb

Front Prop shaft joint worn, but not excessively (6.1.7 (c) (i))

Front Suspension arm corroded but not seriously weakened n/s and o/s front arms upper and lower (5.3.3 (b) (i))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced front chassis corroded (6.1.1 (c) (i))

Nearside Front Lower Obligatory mirror slightly damaged (3.3 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced front chassis corroded (6.1.1 (c) (i))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Tyre slightly damaged/cracking or perishing n/s and o/s rear tyres (5.2.3 (d) (ii))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Obligatory mirror slightly damaged (3.3 (b) (i))

Service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.2.2 (a) (i))

Underside of vehicle has slight corrosion throughout inc suspension components

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Central Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting offside inner sill (6.2.2 (d) (i))

Nearside Front Brake pipe excessively corroded x2 (1.1.11 (c))

Nearside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting wheel arch (6.2.2 (d) (i))

Offside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting wheel arch (6.2.2 (d) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

Nearside Obligatory mirror slightly damaged (3.3 (b) (i))

Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Underside of vehicle has slight corrosion throughout inc suspension components.

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Battery insecure (1.9.1)

Horn not working (1.6.2a)

Parking brake: efficiency below requirements (3.7.B.7)

Front Sub-frame corroded and seriously weakened (2.4.G.1)

Front registration plate deteriorated (6.3.1d)

Nearside Side repeater excessively damaged so that it is not visible from a reasonable distance (1.4.A.2e)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Side repeater incorrect colour (1.4.A.2f)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement front and rear (2.4.G.2)

Offside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement front (2.4.G.2)

Offside Front Suspension component mounting prescribed area is excessively corroded inner wheel arch (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded inner wing (2.4.A.3)

Offside Rear Hydraulic brake cylinder leaking hydraulic fluid caliper (3.6.A.1)

offside rear bump stop missing

all the low brake pads sensor wires disconnected.

front rubber body mountings out of shape. light corrosion arround support brackets.

n/s/f and both rear tyres worn to 4 mm.o/s/f tyre worn to 5 mm. Legal limit 1.6 mm.

o/s handbrake performance 50% lower than the n/s!

tail pipe end corroded.

Battery insecure (1.9.1)

Exhaust has a major leak of exhaust gases (7.1.2)

Fuel pipe insecure (7.2.1)

Nearside Front Electrical wiring insecure (1.9.2a)

Offside Rear Electrical wiring insecure (1.9.2a)

Ecd light glowing on!

all the low brake pads sensor wires disconnected.

front rubber body mountings out of shape. light corrosion arround support brackets.

n/s/f and both rear tyres worn to 4 mm.o/s/f tyre worn to 5 mm. Legal limit 1.6 mm.

o/s handbrake performance 50% lower than the n/s!

tail pipe end corroded.

Oil leak

Play in prop-shaft centre bearing

Play in steering rack inner joint(s)

Under-trays fitted obscuring some underside components

Battery insecure (1.9.1)

Emissions not tested (7.0)

Exhaust system not adequately supported (7.1.1)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Headlamp aim too low (1.8)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Headlamp aim too low (1.8)

Offside Rear Front position lamp(s) not working (1.1.A.3b)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Nail in offside rear tyre

Oil leak

Play in prop-shaft centre bearing

Play in steering rack inner joint(s)

Under-trays fitted obscuring some underside components

gear stick loose

warning light for brakes perminantly illuminated

brake warning lamp on

nearside door release handle loose

nearside repeter lens mising

nearside second mirror broken

offside mirror back missing

offside repeter lens missing

offside second mirror missing

Offside Headlamp aim too high (1.8)

brake warning lamp on

nearside door release handle loose

nearside repeter lens mising

nearside second mirror broken

offside mirror back missing

offside repeter lens missing

offside second mirror missing

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Registration plate lamp not working (1.1.C.1d)

Nearside Rear Lower Leaf spring saddle is moving relative to the spring (2.4.B.7a) DANGEROUS

Offside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2) DANGEROUS

Offside rear parking brake recording little or no effort (3.7.B.6a) DANGEROUS

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)