2008 Toyota Aygo

Brake pipe corroded, covered in grease or other material all front to rear (1.1.11 (c))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Coil spring corroded both sides (5.3.1 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Windscreen wiper blade defective both sides (3.4 (b) (i))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn both sides (5.1.2 (b) (i))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Service brake binding but not excessively both sides (1.2.1 (f))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Seat belt anchorage prescribed area is corroded but not considered excessive both sides inner and outer sills all (7.1.1 (a) (i))

under vehicle prescribed area and suspension/braking components slightly corroded

Brake pipe corroded, covered in grease or other material all front to rear (1.1.11 (c))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Service brake binding but not excessively both sides (1.2.1 (f))

under vehicle prescribed area and suspension/braking components slightly corroded

Brake disc worn, but not excessively both front (1.1.14 (a) (i))

Brake pad(s) wearing thin both front low on inners (1.1.13 (a) (ii))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Brake disc worn, but not excessively both front (1.1.14 (a) (i))

Brake pad(s) wearing thin both front low on inners (1.1.13 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Offside Rear Rear wheel bearing rough when rotated (2.6.1)

Offside Registration plate lamp not working (1.1.C.1d)

front discs corroded slightly

Front Brake pad(s) wearing thin (3.5.1g)

Offside Inner Rear Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Headlamp aim too high (1.8)

Offside Headlamp aim too low (1.8)

Offside Inner Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Front wiper split but still clearing windscreen efficiently