2011 Hyundai Santa Fe

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Lower Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

Rear Upper Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

Fuel system component leaking Leak from fuel tank to fuel filler neck area (6.1.3 (b) (i))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Windscreen wiper blade defective (3.4 (b) (i))

Offside Front Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Windscreen wiper blade defective (3.4 (b) (i))

Windscreen damaged but not adversely affecting driver's view Chip in zone A (3.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Nearside Front Tyre tread depth below requirements of 1.6mm 235/60-18 (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

slight play off side front drop link

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Windscreen damaged but not adversely affecting driver's view Chip in zone A and B (3.2 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Windscreen damaged but not adversely affecting driver's view Chip in zone A and B (3.2 (a) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Outer (chip in offside and nearside less than 10mm not affecting drivers view)

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (main retaining clip missing) (6.1.7 (g) (ii))

Offside Front Headlamp not working on dipped beam (replaced bulb re checked head lamp aim) (4.1.1 (a) (ii))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Outer (chip in offside and nearside less than 10mm not affecting drivers view)

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Outer Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower (small chip in windscreen)

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Lower Suspension arm ball joint excessively worn (detected on shaker plates) (5.3.4 (a) (i))

Nearside Rear Direction indicator incorrect colour (showing white to rear) (4.4.3 (a))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Outer Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower (small chip in windscreen)

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside rear tyre has uneven wear on inner tread

Nearside Side repeater not working (4.4.1 (a) (ii))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Brake disc worn, pitted or scored, but not seriously weakened rear brake discs worn and pitted (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside rear tyre has uneven wear on inner tread

Front Brake pad(s) wearing thin not thin but worn (1.1.13 (a) (ii))

Rear Brake pad(s) wearing thin not thin but worn (1.1.13 (a) (ii))

Offside Front tyre worn on inner edge advise attention

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components