2003 MG Zr

Bonnet cannot be secured in the closed position (8.4.1)

Nearside Headlamp aim too low (1.8)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Headlamp aim too low (1.8)

Rear fog lamp not working (1.3.2b)

Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Registration plate lamp not working (1.1.C.1d)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

front parking (secondary) brakes imbalanced (3.7.B.6b)

Nearside Front Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Inner Tyre worn close to the legal limit edge (4.1.E.1)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Supplementary Restraint System warning lamp does not illuminate (5.4.2)

Nearside Headlamp aim too high (1.8)

Offside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Side repeater not working (1.4.A.2c)

Offside Headlamp aim too high (1.8)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g) DANGEROUS

drivers door hard to open from inside

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

drivers door hard to open from inside

Front Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Front Headlamp not in good working order adversely affecting beam image (1.2.4a)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Headlamp not in good working order adversely affecting beam image (1.2.4a)