2003 Mitsubishi Shogun

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Front Anti-lock braking system component missing (1.6 (e))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front caliper sticking

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Central Exhaust system insecure middle box broken off (6.1.2 (a))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front caliper sticking

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings both side under sils (6.1.B.2)

Rear Brake pad(s) less than 1.5 mm thick both rear (3.5.1g)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Inner Body has slight corrosion sill (6.1.B.2)

general underbody corrosion

o/s inner sill corrosion

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside rear brake juddering slightly (3.7.A.5b)

Offside rear brake juddering slightly (3.7.A.5b)

o/side wiperblade splitting

slight bind n/side rearbrake

Exhaust tailpipe not capable of allowing the emission probe to be inserted (7.4.B.1)