2007 Ford Focus C-max

Emissions unable to be completed (8.2.1.2 (d))

Exhaust emits excessive dense blue smoke during acceleration (8.2.1.2 (g))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Outer sill (6.1.1 (c) (i))

Coil spring corroded Both rear (5.3.1 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced Both outer corroded/ (6.1.1 (c) (i))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Suspension arm corroded but not seriously weakened All rear arms subframe (5.3.3 (b) (i))

Exhaust mounting defective (6.1.2 (a))

Nearside Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Brake disc worn, pitted or scored, but not seriously weakened and corroded inner surfaces front (1.1.14 (a) (ii))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Brake disc worn, pitted or scored, but not seriously weakened and corroded inner surfaces front (1.1.14 (a) (ii))

Exhaust emits blue smoke during acceleration (8.2.1.2 (g))

Offside Front coil spring broken (2.4.C.1a)

offside and nearside front tyres splitting to sidewalls

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Rear Anti-roll bar linkage has excessive play in a pin/bush broken off (2.4.G.2)

offside and nearside front tyres splitting to sidewalls

nearside front tyre slight splitting to side walls

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Suspension arm rubber bush deteriorated resulting in excessive movement offside and nearside front (2.4.G.2)

nearside front tyre slight splitting to side walls

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear rear brake fluctuating, but not excessively (3.7.B.3)

Offside Rear rear brake fluctuating, but not excessively (3.7.B.3)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)