2008 Nissan Navara

Exhaust has a minor leak of exhaust gases flexi section (6.1.2 (a))

Exhaust mounting defective central mount rubbers (6.1.2 (a))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Centre Exhaust Rubbers Missing

Exhaust has a minor leak of exhaust gases Front Flexi (6.1.2 (a))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Hazard warning lamps inoperative (4.4.1 (e))

Hazard warning switch inoperative switch missing (4.4.2 (a) (ii))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Centre Exhaust Rubbers Missing

Exhaust has a minor leak of exhaust gases front flexi (6.1.2 (a))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Center Exhaust Rubbers Missing

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Brake performance not tested (1.2.1 (g))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Hydraulic brake calliper insecurely mounted and braking performance affected (1.1.16 (c) (ii)) DANGEROUS

Offside Front Hydraulic brake calliper insecurely mounted and braking performance affected (1.1.16 (c) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Center Exhaust Rubbers Missing

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Shock absorber has a light misting of oil (2.7.3)

gear has oil leak

Brake pedal spongy (3.3.B.1b)

Nearside Headlamp aim too low (1.8)

Nearside Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high and too far to the right. (1.8)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Side repeater not working (1.4.A.2c)