2009 Citroen Relay

full under tray undersealed

Parking brake efficiency below requirements (1.4.2 (a) (i))

full under tray undersealed

Inner Suspension component mounting repair covered in underseal both sills been replaced and repaired (5.3.6 (a) (i))

Suspension component mounting repair covered in underseal all underneath covered in underseal (5.3.6 (a) (i))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Windscreen washer not working (3.5 (a))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

vehicle has had various underbody repairs all covered in underseal at time of test

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill and inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Suspension component mounting repair covered in underseal sill and inner sill (5.3.6 (a) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Central Exhaust has a minor leak of exhaust gases centre box blowing (6.1.2 (a))

Nearside Exhaust silencer slightly loose rubber missing cable tie used (8.1.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust emissions exceed default limit of 1.5m-1 (8.2.2.2 (b))

Nearside Front Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps both lights inop (4.7.1 (b) (ii))

Exhaust has a minor leak of exhaust gases silencer has a hole in it (6.1.2 (a))

Exhaust mounting defective exhaust rubber missing (cable tied up) (6.1.2 (a))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust rubbers split

Handbrake just met requirements and may need adjustment or repair

Nearside Front Brake binding

Nearside Rear Leaf spring has slight wear in a shackle pin and/or bush Rear bush (5.3.4 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

rear brake binding handbrake sticking on (3.7.B.1)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Brake linkage has restricted free movement (3.5.1k)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Brake cable has a seized clevis joint pivot (3.5.1c)

Offside Brake cable has a seized clevis joint pivot (3.5.1c)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear position lamp(s) not working (1.1.A.3b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Centre Exhaust system not adequately supported (7.1.1)

Nearside Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Headlamp aim too high (1.8)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Outer Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Outer Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Offside Registration plate lamp not working (1.1.C.1d)