2002 Volkswagen Lt

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive spring mounting (5.3.6 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced rear of cab (6.1.1 (c) (i))

Offside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Steering rack has slight free play detected at steering wheel (2.3 (a) (i))

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Fuel cap/sealing device missing (6.1.3 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Anti-roll bar pin or bush excessively worn D bush (5.3.4 (a) (i))

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Anti-roll bar pin or bush excessively worn D bush (5.3.4 (a) (i))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive spring mounting (5.3.6 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced rear of cab (6.1.1 (c) (i))

Offside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Steering rack has slight free play detected at steering wheel (2.3 (a) (i))

Nearside rear parking (secondary) brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.6b)

OIL LEAK

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Power steering component(s) has slight seepage from a component (2.3.3b)

Nearside rear parking (secondary) brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.6b)

OIL LEAK

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp aim too high (1.8)

Power steering component(s) has slight seepage from a component (2.3.3b)

Nearside Seat belt flexible stalk damaged but not likely to lead to failure under load (5.2.4a)

Oil leak

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Exhaust emits blue smoke during acceleration (7.3.A.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear position lamp(s) excessively damaged so that it is not visible from a reasonable distance (1.1.A.3d)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Rear Registration plate lamp not working (1.1.C.1d)

Nearside Front Direction indicators incorrect colour (1.4.A.2f)

Nearside rear tyre has a cut but not deep enough to reach the cords

Nearside rear tyre has a cut but not deep enough to reach the cords

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Rear Rear position lamp(s) deteriorated, but still visible from a reasonable distance (1.1.A.3d)

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

nearside reaar tyre slightly perished(cracked)

front near side indicator lens slightly cracked

rear near side lamp slightly cracked

revers light lens damaged and repaird

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

front near side indicator lens slightly cracked

rear near side lamp slightly cracked

revers light lens damaged and repaird

Brake load sensing valve linkage seized (3.6.E.3)

Brake pedal creeps down under servo assistance and touches the floor (3.3.C.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Windscreen wiper blade insecure (8.2.2)

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)