2008 Ford Ka

Offside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Front Brake hose excessively damaged rubbing against rim on full steering lock. (1.1.12 (b) (ii))

Offside Front Brake hose excessively damaged rubbing against tyre on full steering lock. (1.1.12 (b) (ii))

Both sides outer sills corroded.

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Headlamp aim too low (4.1.2 (a))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Inner Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected sill (5.3.6 (a) (ii)) DANGEROUS

Nearside Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

heavily undersealed

Nearside Front Suspension arm pin or bush excessively worn front (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush excessively worn front (5.3.4 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

heavily undersealed

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement front (5.3.4 (a) (i))

slight corrosion on front and rear subframe mounting points

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement front (5.3.4 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

slight corrosion on front and rear subframe mounting points

exhaust system corroded

one of power steering pipes at nsf corroded

Nearside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Suspension arm rubber bush deteriorated resulting in excessive movement axle arm eye bush (2.4.G.2)

Offside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Suspension arm rubber bush deteriorated resulting in excessive movement axle arm eye bush (2.4.G.2)

exhaust system corroded

one of power steering pipes at nsf corroded

Nearside Headlamp aim too low (1.8)

Nearside Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Headlamp aim too low (1.8)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Offside Inner Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)