2008 Toyota Aygo

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Inner sill corroding

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Inner sill corroding

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Lower Suspension locking device missing (5.3.6 (b))

Offside Front Lower Suspension locking device missing (5.3.6 (b))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Rear fog lamp tell-tale not working (4.9.1 (a) (ii))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Inner sill corroding

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Inner sill corroding

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear axle corroded

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Rear axle corroded

Front Exhaust system insecure (6.1.2 (a))

Front Hazard warning switch inoperative (4.4.2 (a) (ii))

Front Main beam tell-tale not working (4.9.1 (a) (ii))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Rear axle corroded

Nearside Rear Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Rear Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Wishbone Rear Bush (5.3.4 (a) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement Axle Bush (5.3.4 (a) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Wishbone Rear Bush (5.3.4 (a) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement Axle Bush (5.3.4 (a) (i))

Nearside Rear Outer sill corroded

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Hazard warning switch inoperative (4.4.2 (a) (ii))

Nearside Rear Inner Brake pipe excessively corroded (1.1.11 (c))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Inner Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a))

Offside Rear Tyre not fitted in accordance with side wall instructions (5.2.3 (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Inner Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

n/s/f & o/s/f tyres wearing on inner edge

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

n/s and o/s/f tyres worn on inner edge

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

n/s and o/s/f tyres worn on inner edge

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front registration plate character(s) incorrectly spaced (6.3.4a)

Rear registration plate character(s) incorrectly spaced (6.3.4a)