2009 Ford Transit Connect

Nearside Inner Vehicle structure is repaired but structural rigidity is not significantly reduced sill (6.1.1 (d) (i))

Nearside Inner Vehicle structure is repaired but structural rigidity is not significantly reduced sill (6.1.1 (d) (i))

Nearside Outer Vehicle structure is repaired but structural rigidity is not significantly reduced sill (6.1.1 (d) (i))

Offside Outer Vehicle structure is repaired but structural rigidity is not significantly reduced sill (6.1.1 (d) (i))

oil leak from engine

Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Inner Vehicle structure is repaired but structural rigidity is not significantly reduced sill (6.1.1 (d) (i))

Nearside Inner Vehicle structure is repaired but structural rigidity is not significantly reduced sill (6.1.1 (d) (i))

Nearside Outer Vehicle structure is repaired but structural rigidity is not significantly reduced sill (6.1.1 (d) (i))

Offside Outer Vehicle structure is repaired but structural rigidity is not significantly reduced sill (6.1.1 (d) (i))

oil leak from engine

Fuel cap/sealing device missing (6.1.3 (b) (i))

Horn not working (7.7 (a))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Nearside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Nearside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside parking brake low effort

Oil leak, but not excessive (8.4.1 (a) (i))

inner & outer sills corroded both sides

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Central Brake pipe excessively corroded Front to rear X2. (1.1.11 (c))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Outer sill. (6.2.2 (d) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Outer sill. (6.2.2 (d) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Windscreen damaged and affecting the driver's view of the road (3.2 (a) (ii))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

parking brake low effort

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Rear Rear position lamp(s) not working (1.1.A.3b)

Rear fog lamp not working (1.3.2b)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)