2002 Peugeot 206

Brake load sensing valve seized (3.6.E.3)

Brake pipe excessively corroded 3 x rear axel (3.6.B.2c)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases rear box (7.1.2)

Exhaust system not adequately supported all rubbers (7.1.1)

Nearside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Front Front position lamp(s) not working dip beam (1.1.A.3b)

Nearside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Front position lamp(s) not working side light (1.1.A.3b)

Offside Front Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Road wheel bead rim badly distorted (4.2.A.1a)

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Rear Registration plate lamp not working (1.1.C.1d)

Rear registration plate deteriorated (6.3.1d)

Stop lamp adversely affected by the operation of another lamp both rear (1.2.1f)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

front discs rusty

Nearside Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Anti-roll bar ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front constant velocity joint is slightly worn (2.5.C.1b)

Exhaust system not adequately supported (7.1.1)

Nearside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Front wheel bearing rough when rotated (2.5.A.2)

Nearside Front Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Side repeater incorrect colour (1.4.A.2f)

Offside Rear Stop lamp not working (1.2.1b)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust has part of the system excessively deteriorated (7.1.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Registration plate lamp not working (1.1.C.1d)

indicator switch in poor condition

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

indicator switch in poor condition

suspect fault in n/s/rear brake