2002 Peugeot 206

Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Rear Exhaust system insecure (6.1.2 (a))

Rear Registration plate insecure (0.1 (a))

Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Coil spring corroded BOTH SIDES (5.3.1 (b) (i))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Upper Strutt mount bearing rough when turned

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Registration plate insecure but not likely to fall off (0.1 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Brake pipe excessively corroded Front To Rear X1 (1.1.11 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Rear Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a))

Front Coil spring corroded BOTH SIDES (5.3.1 (b) (i))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Upper Strutt mount bearing rough when turned

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Registration plate insecure but not likely to fall off (0.1 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Tyre worn on inner edge

Oil leak ()

Power steering pulley has a slight wobble

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Brake hose ferrule excessively corroded (3.6.B.4e)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Offside Rear Tyre worn on inner edge

Oil leak ()

Power steering pulley has a slight wobble

Nearside Front tyre wearing on inner edge

Nearside Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front tyre worn on inner edge

Offside Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement front bush (2.4.G.2)

Offside Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Oil leak ()

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Tyre tread depth below requirements of 1.6mm 175 65 14 (4.1.E.1)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front tyre wearing on inner edge

Nearside Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front tyre worn on inner edge

Offside Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement front bush (2.4.G.2)

Offside Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Oil leak ()

Nearside Front Tyre tread depth below requirements of 1.6mm 175 65 14 (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

oil leak

Oil leak

nearside rear tyre deteriorating

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear position lamp(s) not working (1.1.A.3b)

rear brake application uneven (3.7.B.2)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Oil leak

nearside rear tyre deteriorating

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside rear tyre cracking on sidewall

Oil leak

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Side repeater incorrect colour (1.4.A.2f)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside rear tyre cracking on sidewall

Oil leak

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Brake load sensing valve linkage stiff (3.6.E.3)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

both front tyres wearing on inner edge

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Registration plate lamp not working (1.1.C.1d)

rear brake application uneven (3.7.B.2)

Brake load sensing valve linkage stiff (3.6.E.3)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Headlamp aim too low (1.8)

both front tyres wearing on inner edge

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

front discs wearing

Nail in offside rear tyre

Brake load sensing valve linkage seized (3.6.E.3)

Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Nail in offside rear tyre

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Stop lamp not working (1.2.1b)

Nearside Rear position lamp(s) obscured more than 50% (1.1.A.3c)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Registration plate lamp not working (1.1.5c)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Registration plate lamp not working (1.1.5c)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Registration plate lamp not working (1.1.5c)

Exhaust has part of the system excessively deteriorated (7.1.1a)

Rear Exhaust has part of the system excessively deteriorated (7.1.1a)