2003 Toyota Corolla

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Coil spring corroded (5.3.1 (b) (i))

Front Coil spring corroded (5.3.1 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Headlamp has a product on the lens but not seriously reducing light output both side (4.1.4 (b))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Coil spring corroded (5.3.1 (b) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear drum back plate corroded

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

hand brake high

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Coil spring corroded and rear (5.3.1 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Suspension arm corroded but not seriously weakened both side (5.3.3 (b) (i))

Headlamp has a product on the lens but not seriously reducing light output both side (4.1.4 (b))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Tyre worn close to legal limit/worn on edge both side (5.2.3 (e))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced by sub-frame bracket (6.1.1 (c) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

hand brake high

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Service brake binding but not excessively both side (1.2.1 (f))

Front Suspension arm pin or bush worn but not resulting in excessive movement both side (5.3.4 (a) (i))

Headlamp has a product on the lens but not seriously reducing light output both side (4.1.4 (b))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced both side (6.1.1 (c) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

exhaust corroded

hand brake high

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Brake pad(s) wearing thin BOTH SIDES (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened BOTH SIDES (3.5.1i)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Parking brake lever has little reserve travel (3.1.6b)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Front coil spring corroded (2.4.C.1b)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)