2003 Mazda MX-5

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust has a major leak of exhaust gases manifold area (6.1.2 (a))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected chasis leg anti roll bar mount area (5.3.6 (a) (ii)) DANGEROUS

Offside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected chasis leg antiroll bar mount area (5.3.6 (a) (ii)) DANGEROUS

Nearside Front Obligatory mirror slightly damaged (3.3 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Stop lamp not working (1.2.1b)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Parking brake lever has little reserve travel (3.1.6b)

parking brake only just met requirements suggest further inspection

Nearside Rear Brake pipe excessively corroded across subframe (3.6.B.2c)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Offside Rear wheel bearing has excessive play (2.6.2)

Offside Rear wheel bearing rough when rotated (2.6.1)

Rear Brakes imbalanced across an axle (3.7.B.5b)

Registration plate lamp not working (1.1.C.1d)

rear brake application uneven (3.7.B.2)

Car floor has corrosion

Nearside Front Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

nearside rear outer sill corroding

both front tyres close to minimum limit.

nearside rear tyre close to minimum limit.