2003 Mercedes-benz Vito

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Towbar excessively corroded within 30cm of towbar mounting (6.1.6 (i) (i))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner jacking point (5.3.6 (a) (i))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced centre outer sill (7.1.1 (a) (i))

Offside Towbar excessively corroded within 30cm of towbar mounting (6.1.6 (i) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Inner Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Rear Inner Body has slight corrosion (6.1.B.2)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Anti-roll bar ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Side repeater slightly discoloured (1.4.A.2f)

Offside Front Side repeater slightly discoloured (1.4.A.2f)

Play in steering rack inner joint(s)

Brake load sensing valve seized (3.6.E.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Headlamp aim too low (1.8)

Offside Front Shock absorber has a serious fluid leak (2.7.3)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Side repeater slightly discoloured (1.4.A.2f)

Offside Front Side repeater slightly discoloured (1.4.A.2f)

Play in steering rack inner joint(s)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Brake load sensing valve linkage seized (3.6.E.3)

Nearside Headlamp aim too low (1.8)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Registration plate lamp not working (1.1.C.1d)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

front and rear brake discs excessively pitted

Brakes imbalanced across an axle (3.7.B.5b)

front and rear brake discs excessively pitted

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Side repeater slightly discoloured (1.4.A.2f)

both wiper blades started to split.

some damage on n/s/f seat belt buckle casing.

Front registration plate deteriorated (6.3.1d)

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Nearside Registration plate lamp not working (1.1.5c)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Brake hose excessively deteriorated (3.6.B.4d) DANGEROUS

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Side repeater slightly discoloured (1.4.A.2f)

both wiper blades started to split.

some damage on n/s/f seat belt buckle casing.

hand brake tight

some grease around n/s/f outer c.v.boot

Front Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Nearside Headlamp aim too high when the centre of the headlamp is above 850mm from the ground (1.6.B3)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too high when the centre of the headlamp is above 850mm from the ground (1.6.B3)

hand brake efficiency just efficient at time of mot test

hand brake efficiency just efficient at time of mot test