2007 Mercedes-benz C

Coil spring worn all (5.3.1 (b) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Coil spring worn all (5.3.1 (b) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside Rear Brake hose slightly deteriorated (1.1.12 (b) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Exhaust mounting defective (6.1.2 (a))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Rear Shock absorber casings corroded

Corrosion to both rear shock absorber casings

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Rear bush (5.3.4 (a) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Rear bush (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Corrosion to both rear shock absorber casings

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Rear bush (5.3.4 (a) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Rear bush (5.3.4 (a) (i))

Parking brake: efficiency below requirements (3.7.B.7)

Under-trays fitted obscuring some underside components

centre brake light inop

nearside front tyre cut but no chords showing

Both front tyres worn close to limit.

Both rear tyres on 1.6mm limit.

Brake pad wear indicator showing on instrument panel.

Front brake discs worn very thin.

Front brake pads very low.

Nearside Front wheel bearing has slight play (2.5.A.3c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Tyre worn close to the legal limit (4.1.E.1)

hand brake in need of adjustment

nearside front tyre cracking on side wall

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Tyre worn close to the legal limit (4.1.E.1)

hand brake in need of adjustment

nearside front tyre cracking on side wall