2007 Mercedes-benz Vito

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced both wheelarches (6.1.1 (c) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear body wheel arch corrosion

Offside Rear Direction indicator slightly discoloured (4.4.3 (a))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

brake pad wear light on

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear body wheel arch corrosion

Offside Rear Direction indicator slightly discoloured (4.4.3 (a))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

brake pad wear light on

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Windscreen washer not working (3.5 (a))

Offside Front Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Indicator switch insecure (4.4.2 (a) (i))

Central Prop shaft bearing housing insecure (6.1.7 (f) (i))

Nearside Headlamp are incorrectly positioned bulb (4.1.4 (a))

Offside Front Electrical wiring insulation so damaged or deteriorated it is likely to cause a short-circuit abs / pad warning cable's (4.11 (c) (ii))

Indicator switch insecure (4.4.2 (a) (i))

park warning light fault