2008 Mercedes-benz Vito

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Brake pipe corroded, covered in grease or other material front to rear at rear (1.1.11 (c))

Offside Rear Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Inner Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

centre exhaust heat shield insecure

Suspension component mounting prescribed area damaged but not considered excessive (5.3.6 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge note tyre tread depth 3.0 mm limit 1.6 mm 195/65/16c (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge note tyre tread depth 2.0 mm limit 1.6 mm 195/65/16c (5.2.3 (e))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Rear Position lamp not working (4.2.1 (a))

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge note tyre tread depth 3.0 mm limit 1.6 mm 195/65/16c (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge note tyre tread depth 2.0 mm limit 1.6 mm 195/65/16c (5.2.3 (e))

Both front tyres worn on outer edge

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside Loading door cannot be secured in the closed position (6.4.1)

Offside front brake excessively fluctuating (3.7.B.3)

Parking brake: efficiency below requirements (3.7.B.7)

Both front tyres worn on outer edge

O/s front fog lamp not working

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Advise b/pads low o/s/r

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

rear exhaust tail pipe corroded and holed within the limit.

Electronic stability system warning lamp indicates a fault (3.4.1c)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside Front Headlamp aim too low (1.8)

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear fog lamp not working (1.3.2b)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

rear exhaust tail pipe corroded and holed within the limit.

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Registration plate lamp not working (1.1.C.1d)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear coil spring incomplete (2.4.C.1a)

Offside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Offside Headlamp aim too high (1.8)

Offside Rear coil spring incomplete (2.4.C.1a)

Offside Registration plate lamp not working (1.1.C.1d)

Parking brake lever has no reserve travel (3.1.6b)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Brake pad(s) wearing thin (3.5.1g)

Front registration plate insecure (6.3.1b)

Nearside Headlamp aim too low (1.8)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too low and too far to the left. (1.8)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Stop lamp not working (1.2.1b)